Monday, September 11, 2017

Pop-Up Pumpkin . . . and Toad

Hi, Lois here in the throes of Hurricane Irma.  But I do have a card for you today.  Halloween  is right around the corner, and I've got another card made with a new CottageCutz Halloween die.  This was a fun card to make.  When you look at the front, it's not very exciting, BUT . . .


. . . all the fun is on the inside!


To start my base card, I cut cardstock as follows:

Orange - 8 1/2" x 5 1/2"
Black - (1) 4" x 5 1/4", (1) 5 1/4" x 8 1/4", cut in half
Patterned Paper - (1) 3 7/8" x 5 1/8", (1) 5 1/8" x 8 1/8", folded in half


After folding  the orange base in half, I glued down the black mat piece and the smaller patterned paper piece on the front.

I cut all the die cuts from white, orange, black, or green cardstock . . . 


. . . and colored them with either ink or markers.  Then I constructed the frog/pumpkin piece.  Note that the small stars and curly-cue are glued to a small piece of acetate, which was then glued to the large star on the wand with a glue dot.


On the front I stamped the sentiment and the cat in Versafine Black Onyx ink and embossed them with clear embossing powder . . .

. . . and added the scarecrow and strip of grass.


Now came the fun part!  To make my pop-up support on the inside, I cut two 2" slits 1" apart on the patterned paper across the scored center and scored at each end of the strips.


I glued the two pieces of black cardstock to the inside of the card, getting them close to the fold line, but not touching.  This allows the card to close without bending up the edges.  I didn't want to adhere one large piece of black cardstock to the inside because that would tend to "bind" when the card was closed.  Then I added the patterned paper, being careful not to apply glue to the support section in the center.  This section will fold OUT when the card is closed -- with the pumpkin/frog glued to the front of it.


Because the paper is very "busy," I wanted to tone it down a bit by putting a panel on each side of the card.  I cut two pieces of black cardstock, one piece of white, and one piece of "sky" paper.  (These could be any size you wanted.)


I stamped the sentiment on the white piece and sponged a bit of green ink around the edges.


I then cut out the sun and cloud, sponged on some darker color to the sun, and (using a Copic gray marker) added some shading to the under side of the cloud.


I put the pieces together and adhered them to the upper and lower panels of the card.


This photo shows how the frog sits on the pop-up support piece.


CottageCutz dies used on this card are:

http://www.scrappingcottage.com/cottagecutzharvestscarecrowelites.aspx



http://www.scrappingcottage.com/cottagecutzsunandcloud.aspx




The new Halloween die (Happy Toad Wizard), as well as several new series of Christmas dies, will be available for purchase in the CottageCutz store starting September 20th.  Because of the support of their wonderful customers, it has become necessary to move into a larger warehouse.  Because of the move, the store is temporarily on hold.  But that gives you lots of time to decide what you want next!  LOL!



5 comments:

SugarShine Designs said...

My gosh, your card so fun! Love the halloween die in this one too. Super cute! - Janet

Anja Ž. said...

Lois, what a great card design! I love the outside and the inside of the card.

Pam MacKay said...

Adorable love that Halloween toad! Hope you are Ok!

Jeanne said...

Lois this card is absolutely the the best! That toad is adorable and I love the pop-up!

Mary Marsh said...

super cute card Lois - these new dies are just so sweet and you did a great job with them - love the pop-up